How to put a field point back on with hot-melt glue

Our instruction sheet for Ferr-L-Tite hot-melt glue, written in 2020. If a point comes off one of our darts, this is how to fix it.

Ferr-L-Tite is a hot-melt stick glue made for holding arrow and dart points. A point glued on this way can be heated and taken off again later.

You’ll need

  • A stick of Ferr-L-Tite hot-melt glue
  • A heat source: an open flame, gas stove burner, heat gun or propane torch
  • Pliers
  • Gloves
  • A cup of cold water

Steps

  1. Make sure the gluing surfaces are free of paint, lacquer or oil.
  2. Put on gloves. Hold the end of the glue stick with pliers and heat it.
  3. Dab a small amount of glue on the tapered end of the dart.
  4. Hold the field point with pliers and heat it.
  5. Push the hot point onto the end of the dart with a twisting, pushing motion.
  6. Dip the hot point into cold water to help the glue bond.
  7. Stand the dart up, point up, until the point cools.

Putting a field point on a dart → · Points and supplies →

Leave a Reply

Your email address will not be published. Required fields are marked *

Older post
Newer post