How thick should an atlatl dart be? (And making hardwood darts)

Bob’s answer to a customer, 2007.

As an approximate rule:

  • Darts 40 to 60 inches long: 3/8 inch thick
  • Darts 60 to 80 inches: 1/2 inch
  • Darts 80 to 90 inches: 9/16 inch

To get something that works more perfectly, start with longer shafts and try them. If the spine is too light (the dart wobbles too much), cut a little off the front end and try it again. Hardwood varies a lot in density and stiffness, so your success will depend a lot on which hardwood you use.

Making hardwood darts

The trick to making good hardwood darts is to start with logs that are straight and without knots. Saw boards from the log parallel to the grain by following the natural taper of the tree; you can do this with a chainsaw mill. I make the planks a little thicker than twice the thickness of the darts. With a table saw, saw the planks into square strips, then saw off the corners to make an octagon. Use feather boards to hold the darts against the saw fence.

Hardwood darts are best cut from green wood, bundled together with string and left to dry. As they dry, take them out of the bundle, straighten them and re-bundle tightly. I use four fletches about 6 to 7 inches long on eight-sided darts. You can make a tool for rounding darts with a router if you want to spend the time. Use a cabinet scraper to remove the saw marks. I hope this helps.

How to pick your darts →

Leave a Reply

Your email address will not be published. Required fields are marked *

Older post
Newer post